Aqua Epoxy Putty
Selsil Aqua Epoxy Putty is a two-component epoxy putty consisting of resin and hardener, applied by kneading by hand. It can be used on wet surfaces and under water. It provides excellent adhesion even under fresh or salt water. It adheres strongly to almost all materials except PE, PP, Teflon and polyamide.
- It does not contain solvents.
- After curing, it is resistant to water, heat and impacts.
- No shrinkage or loss of volume.
- Waterproof.
- It reaches touch dryness in 30 minutes.
- Once cured, it can be sanded, painted, drilled and machined.
Technical Specifications
| Feature | Conclusion |
|---|---|
| Chemical Structure | Filled Epoxy |
| Drying Time (Tack Free Time) | 30 min |
| Hardness (Shore D) | 75 ShD |
| Compressive Strength | 50 MPa |
| Density | 1.9g/cm³ |
| Pull | None |
| Temperature Resistance (after cure) | 120 °C |
| Chemical Resistance | Alcohol, ketone, hydrocarbon, dilute acids and bases, salt solutions |
| Curing Time | Varies depending on ambient temperature and humidity |
Similar Products
Questions & Answers
Yes. It bonds to wet surfaces and underwater in fresh or salt water.
Cut off the amount needed and knead it by hand until the colour is uniform. Apply within 10 minutes of kneading.
Press the putty onto the area to be repaired. Maintain pressure until it has fully bonded.
Do not use it on PE, PP, Teflon or polyamide surfaces.
It becomes touch-dry after approximately 30 minutes. After 1 hour, it can be drilled, sanded and painted.
No. It does not shrink or lose volume.
Yes. The cured product withstands 120 °C.
Keep the lid closed and store in a cool, dry, ventilated place at 10–25 °C. Its shelf life at room conditions is 24 months.